Microwave Signal Generator, Dual Channel – SynthHD
The Windfreak SynthHD RF Signal Generator brings in a new era of low cost Microwave Signal Generation.
HD stands for HIGH DEFINITION:
- 54 MHZ to 13.6 GHZ in 0.1 Hz steps
- -50 dBm to +20 dBm (typical) in 0.01 dB steps
- Set each channel to independent frequencies, amplitudes and coherent phases
- 0 to 360 degrees relative channel to channel phase control in 0.01 degree steps
- Pulse, AM and FM internal modulation including FMCW radar chirp
- Pulse Modulation with 1uS minimum width and 1uS resolution
- Pulse, AM and FM external modulation from DC – 10KHz
- Powerful Trigger modes allow external triggering of most functions
- Linear and list mode (frequency hopping) sweeps include dual channel differential sweeps
- Save all settings to the device for use without a PC
- 32 bit ARM processor on board which is Arduino compatible (Teensy 3.2)
- Digital schematics and complete Labview GUI source code included with purchase
- Windows, Linux and Android compatibility
- Designed and manufactured in the USA with maximized value / cost ratio
Downloads for SynthHD:
- Datasheet
- Software Users Guide
- Control Software GUI Download (hit Cancel during hardware search if demo-ing software)
- Linux & Windows Command Line Guide
- SynthHD Press Release
New version 1.4 hardware released on April 18th, 2016 – Serial # 208 and higher only:
Version 1.4 hardware requires version 2 software. Version 2 software is not backwards compatible with version 1.3 hardware and older due to physical hardware changes on the boards. Version 1.4 hardware improvements are:
- Storage of calibration files in hardware
- Send RF power commands in dBm rather than raw DAC values
- Simpler customer software writing concerning RF power setting
- Added high accuracy RF calibration capability
- Added external modulation capability for FM, AM and Pulse
- Added low jitter mode for radar applications
- Improved pulse circuitry for better Pulse Modulation
