|
DE0-Nano-SoC Kit/Atlas-SoC Kit
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 SDRAM (32-bit data bus)(HPS)
- Arduino Expansion Header (Uno R3 Compatibility), UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit Ethernet and GPIO Headers
|
|
|
VEEK-MT-SoCKit
- Equipped with an 7-inch amorphous-TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
- Module composed of LED backlight
- Supports 24-bit parallel RGB interface
- Converting the X/Y touch coordinates to corresponding digital data via Touch controller.
|
|
|
DE0-CV Board
- Cyclone V 5CEBA4F23C7N Device
- 4-bit Resistor VGA
- Provides SPI and 4-bit SD mode for SD Card access
- Serial Configuration device – EPCS64
- 64MB SDRAM, x16 bits data bus
- On-Board USB Blaster (Normal type B USB)
|
|
|
DE1-SoC-MTL2
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 and 64MB SDRAM
- VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers
- Touch & LCD Spec
|
|
|
DE1-SoC Board
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 and 64MB SDRAM
- VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers
|
|
|
SoCKit - the Development Kit for New SoC Device
- Cyclone V SX SoC with Dual-core ARM Cortex-A9 (HPS)
- 2GB DDR3, 128MB QSPI Flash, EPCQ256
- SD-card, USB OTG, LCD, Ethernet, UART to USB, Transceiver, HSMC
|
|
|
Cyclone V GX Starter Kit
- Cyclone V GX 5CGXFC5C6F27C7N Device
- LPDDR2, SRAM, FLASH EPCQ256
- Arduino Header, 2x20 GPIO Header, HSMC, UART to USB, HSMC, HDMI TX
|
|
|
VEEK-MT-C5SoC
- Cyclone V SX SoC—5CSXFC6D6F31C6N (SoC)
- 5-Megapixel Digital Image Sensor Module
- 7" LCD Touch Screen Module
|
|
|
Cyclone V SoC Development Kit and SoC Embedded Design Suite
- Cyclone V SX SoC—5CSXFC6D6F31C6N (SoC)
- Hard processor system (HPS)
- DDR3, QSPI Flash, Micro-SD Card
|
|
|
Cyclone V GT FPGA Development Kit
- FPGA prototyping
- FPGA power measurement
- Transceiver I/O performance up to 5.0 Gbps
- PCI Express® (PCIe® ) Gen2 x4 (at 5.0 Gbps per lane)
- Endpoint or rootport support
|
|
|
Altera Cyclone V E FPGA Development Kit
- Cyclone V E FPGA - 5CEFA7F31C7NES
- DDR3 x32 at 300 MHz (soft memory controller)
- On-board USB-BlasterTM II cable (USB, PHY, Max® V CPLD)
|
|
|